Rear Left Sensor

Air Bag Sensor Rear LH:

REPLACEMENT

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Installation is in the reverse order of removal.

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

3. REMOVE TONNEAU COVER ASSEMBLY
4. REMOVE FRONT DOOR SCUFF PLATE LH
5. REMOVE FRONT DOOR WEATHERSTRIP LH
6. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH




7. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector from the airbag sensor rear LH.
b. Remove the 2 nuts and the airbag sensor rear LH.

8. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor rear LH with the 2 nuts.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor rear LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the airbag sensor rear LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

d. Check that there is no looseness in the installation parts of the airbag sensor rear LH.
e. Connect the connector to the airbag sensor rear LH.

9. CONNECT BATTERY NEGATIVE TERMINAL
When disconnecting the battery terminal, initialize the following systems after the terminal is reconnected.
- Power window control system
- Sliding roof system

10. INSPECT SRS WARNING LIGHT