Programming and Relearning

SUPPLEMENTAL RESTRAINT SYSTEM

PRECAUTION

NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.
- Power Window Control System
- Sliding Roof System

1. HANDLING PRECAUTIONS FOR AIRBAG SENSOR

HINT: In this section, the airbag sensor assembly center, airbag sensor front LH, airbag sensor front RH, side airbag sensor assembly LH, side airbag sensor assembly RH, airbag sensor rear LH, airbag sensor rear RH and seat position airbag sensor are collectively referred to as the airbag sensor.

a. Before starting the following operations, wait at least 90 seconds after disconnecting the negative (-) terminal of the battery:
1. Replacement of the airbag sensor.
2. Adjustment of the front doors of the vehicle equipped with the side airbag and curtain shield airbag (fitting adjustment).

b. When connecting or disconnecting the airbag sensor connector, ensure that all of the senors are installed in the vehicle.
c. Do not use an airbag sensor which has been dropped during the operation or transportation.
d. Do not disassemble the airbag sensor.

2. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT
a. When the airbag has not deployed, confirm the DTC by checking the SRS warning light. If there is any malfunction in the SRS airbag system, perform troubleshooting.
b. When any of the airbags have deployed, replace the airbag sensor and check the installation condition.