Transmission Speed Sensor: Service and Repair

SPEED SENSOR (ATM)
REPLACEMENT





NOTICE: When disconnecting the battery terminal, initialize the system(s) shown after the terminal is reconnected.

1. REMOVE BATTERY
2. REMOVE BATTERY CARRIER
3. REMOVE AIR CLEANER ASSEMBLY





4. REMOVE SPEED SENSOR (NT SENSOR)
a. Disconnect the speed sensor connector.
b. Remove the bolt and speed sensor.





5. REMOVE SPEED SENSOR (NC SENSOR)
a. Disconnect the speed sensor connector.
b. Remove the bolt and speed sensor.





6. INSTALL SPEED SENSOR (NC SENSOR)
a. Coat the O-ring of the speed sensor with ATF.
b. Install the speed sensor with the bolt.
Torque: 8.8 Nm (90 kgf-cm, 78 inch lbs.)
c. Connect the speed sensor connector.





7. INSTALL SPEED SENSOR (NT SENSOR)
a. Coat the O-ring of the speed sensor with ATF.
b. Install the speed sensor with the bolt.
Torque: 11 Nm (115 kgf-cm, 8 ft. lbs.)
c. Connect the speed sensor connector.
8. INSTALL AIR CLEANER ASSEMBLY
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
9. INSTALL BATTERY CARRIER
Torque: 13 Nm (130 kgf-cm, 10 ft. lbs.)
10. INSTALL BATTERY