Test Mode (Using SST Check Wire)

TEST MODE (USING SST CHECK WIRE)




a. Make sure that the ignition switch is off.
b. Using SST, connect terminals TS and CG of the DLC3.

SST 09843-18040

c. Turn the ignition switch to the ON position.




d. Press the tire pressure warning reset switch.
e. Check that the tire pressure warning lamp comes on.

HINT:
- Unless (d) is performed, the tire pressure warning lamp remains off while in test mode.
- When there is a problem with the tire pressure warning system, the tire pressure warning lamp blinks at 0.5 second intervals.

If the lamp output result is not normal, proceed to the problem symptoms table or TS terminal circuit.

Item
Problem symptoms table
TS terminal circuit

f. Turn the ignition switch off.
g. Remove the SST from the DLC3.

SST 09843-18040




h. Turn the ignition switch to the ON position.
i. Check that the tire pressure warning lamp goes off.