Shifter M/T: Service and Repair

FLOOR SHIFT SHIFT LEVER ASSY (MTM)
REPLACEMENT
1. REMOVE SHIFT LEVER KNOB SUB-ASSY
2. REMOVE CONSOLE BOX SUB-ASSY REAR





3. SEPARATE FLOOR SHIFT SHIFT LEVER ASSY
a. Separate the wire harness.





b. Remove the 4 bolts and the shift lever assy.





4. SEPARATE TRANSMISSION CONTROL CABLE ASSY
a. Remove the clip, and separate the cable end of the transmission control select cable from the floor shift shift lever assy.





b. Using a screwdriver, release the claw.
c. Separate the transmission control select cable from the floor shift shift lever assy.





d. Remove the clip, and separate the cable end of the transmission control shift cable from the floor shift shift lever assy.





e. Using a screwdriver, release the claw.
f. Separate the transmission control shift cable from the floor shift shift lever assy.





5. INSTALL FLOOR SHIFT SHIFT LEVER ASSY
a. Install the shift lever assy with the 4 bolts.
Torque: 12 Nm (120 kgf-cm, 9 ft. lbs.)





b. Install the wire harness.





6. CONNECT TRANSMISSION CONTROL CABLE ASSY
a. Connect the transmission control shift cable to the floor shift shift lever assy.
b. Connect the end of the transmission control shift cable to the floor shift shift lever assy and install the clip.





c. Connect the transmission control select cable to the floor shift shift lever assy.
d. Connect the end of the transmission control select cable to the floor shift shift lever assy and install the clip.

NOTICE:
^ The serrate part of the select cable point should face upward when the select cable point is connected.
^ The clip should be inserted in the direction as shown In the Illustration.

7. INSTALL CONSOLE BOX SUB-ASSY REAR
8. INSTALL SHIFT LEVER KNOB SUB-ASSY