Shift Lever Rod Universal Joint Replacement

Shift Lever Rod Universal Joint Replacement

Special Tools

KM-569-A Plug Remover

Removal Procedure

1. Position the transmission control lever into 4th gear.
2. Remove the battery tray. Refer to Battery Tray Replacement (Service and Repair).




3. Release the selector lever.

Important: Do not remove the bolt.


4. Loosen the bolt (1) for the relay point clamp.
5. Disconnect the transmission rocker arm from the relay point bracket.
6. Disconnect the 2 retaining clamps (1, 2) from the transmission rocker arm.




7. Disconnect the selector lever from the universal joint.

* Press in retaining spring (arrow) of the hollow pin (3).
* Detach the hollow pin with KM-569-A .

Installation Procedure

Important: Use new retaining clamps.


1. Connect the transmission rocker arm to the relay point bracket.
Connect the 2 retaining clamps (1, 2) to the transmission rocker arm.





Important: Use a new hollow pin. Retaining spring (arrow) of hollow pin (3) must engage.


2. Connect the selector lever to the universal joint.
Connect a hollow pin.
3. Connect the selector lever to relay point.
Important: Do not tighten bolt (1) yet.





4. Install battery tray. Refer to Battery Tray Replacement (Service and Repair).
5. Adjust the transmission shift linkage. Refer to Selector Lever Link Adjustment (Adjustments).
6. For programming procedures, refer to Control Module References (Programming and Relearning).