Luggage Shade Retainer Replacement (Sedan)

Luggage Shade Retainer Replacement (Sedan)

Removal Procedure




1. Remove the rear seat.

* Disconnect at the loop (1) and support in rear area (arrow).
* Remove the rear seat upwards.




2. Remove the rear seat backrest.

* Remove the 3 bolts at the front.
* Remove the 3 belt buckles.
* Fold down the rear seat backrest.
* Remove the 3 bolts at the back.




3. Remove the rear seat backrest.
Remove the rear seat backrest from the side guide.




4. Remove the lower quarter trim panel.
Release the 3 clips (arrows) and remove.
5. Remove the seat belt on lower quarter trim panel.
Remove the bolt.




6. Remove the upper quarter trim panel.

* Release the access panel (1).
* Release the upper quarter trim panel.
* Release the 5 clips.
* Unthread the seat belt.
* Remove the upper quarter trim panel.




7. Remove the rear compartment sill panel.

* Release carefully in the upper area (2) with a plastic wedge.
* Release the 4 clips.
* Release in the lower area in the direction of the interior.
* Release the 4 clips.




8. Remove the rear quarter trim panel.

* Remove the 3 bolts (1).
* Disconnect the wiring harness plug.
* Loosen 3 clips.
* Remove the quarter trim panel.




9. Remove the luggage shade retainer (1).

Installation Procedure

1. Install the luggage shade retainer.
Insert and install the luggage shade retainer.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the rear quarter trim panel.

* Connect the wiring harness plug.
* Install the 3 clips.

Tighten the 3 bolts to 2.5 Nm (22 lb in).

3. Install the rear compartment sill trim.
Install the 8 clips.
4. Install the upper quarter trim panel.

* Thread in seat belt.
* Install the upper quarter trim panel.
* Install the panel.

5. Install the seat belt.

Tighten the bolt to 35 Nm (26 lb ft).

6. Install the lower quarter trim panel.
Install the 3 clips.
7. Insert the rear seat backrest.
Insert the rear seat backrest into side guide.
8. Install the rear seat backrest.

Tighten the 3 rear bolts to 20 Nm (15 lb ft).

* Tighten the 3 rear bolts.
* Fold down the rear seat backrest.

Tighten the 3 front bolts with seat belt buckle to 35 Nm (26 lb ft).

9. Install the rear seat.
Insert the rear seat cushion and position.