Center Pillar Upper Garnish Molding Replacement (Coupe)

Center Pillar Upper Garnish Molding Replacement (Coupe)

Removal Procedure




1. Remove the center pillar deflection sheave.

* Remove the bolt.
* Remove the deflection sheave cover (2).

2. Remove the upper center pillar trim.

* Release the 2 airbag access panel (1).
* Release the 2 center pillar clips with a plastic wedge.

Installation Procedure

1. Install the upper center pillar trim.

* Install the 2 center access pillars.
* Install the 2 airbag panel clips.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the center pillar deflection sheave.

Tighten the bolt to 30 Nm (22 lb ft).

3. Install the deflection sheave cover.