Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Disconnect the engine wiring harness electrical connector (2) from the engine oil pressure sensor.




3. Remove the engine oil pressure sensor.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the engine oil pressure sensor.

Tighten the sensor to 22 N.m (16 lb ft).





2. Connect the engine wiring harness electrical connector (2) to the engine oil pressure sensor.
3. Lower the vehicle.