P080A

DTC P080A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC P080A
- Clutch Pedal Position (CPP) Not Learned




Circuit/System Description

The clutch pedal position (CPP) sensor is an input to the engine control module (ECM). The CPP will be more than 4 volts when the clutch pedal is released and less then 1 volt when the clutch pedal is applied. The CPP is a potentiometer type sensor with the following circuits:

* A 5-volt reference circuit
* A low reference circuit
* A signal circuit



Conditions for Running the DTC

Clutch pedal fully applied.


Conditions for Setting the DTC

Clutch pedal position not learned.


Action Taken When the DTC Sets

P080A is a Type B DTC.


Conditions for Clearing the MIL/DTC

P080A is a Type B DTC.


Reference Information
Schematic Reference

Manual Transmission Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Transmission System Description and Operation (Solstice) (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning)


Circuit/System Verification

Perform the clutch pedal position sensor learn procedure.


Circuit/System Testing

Perform the clutch pedal position sensor learn procedure.


Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Clutch Pedal Position Sensor Learn (Programming and Relearning)
* Control Module References (Programming and Relearning) for ECM replacement, setup and programming.