Driver/Vehicle Information Display: Service and Repair

Driver Information Display Replacement

Special Tools

KM6067 Radio Removal Tool


Removal Procedure

1. Disconnect the battery.





Important: Press the removal bars outwards and at the same time pull the radio out of bracket.


2. Remove the radio.

* Insert the removal bars KM6067 into the mounting holes (arrows) and pull out the radio.
* Disconnect the 2 wiring harness plugs (1, 2).





3. Remove the heating/air conditioning control. Refer to Heater and Air Conditioning Control Replacement (Service and Repair) .

* Release the 2 clips (1).
* Disconnect the 2 wiring harness plugs (2).





4. Remove the panel, instrument panel padding.

* Remove the 2 bolts (1).
* Disconnect the wiring harness plug (2).





5. Remove the information display.

* Remove the 2 bolts (1).
* Release and disconnect the wiring harness plug.

6. Remove the information display panel.
Release the 2 clips and remove upwards.



Installation Procedure

1. Install the info display panel.
Install the 2 clips.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the information display.
Connect and latch the wiring harness plug.

Tighten the 2 bolts to 2.5 N.m (22 lb in).

3. Install the panel, instrument panel padding.

* Connect the wiring harness plug.
* Install the 2 clips.

Tighten the 2 bolts to 2.5 N.m (22 lb in).


4. Install the heating/air conditioning control. Refer to Heater and Air Conditioning Control Replacement (Service and Repair) .

* Connect the 2 wiring harness plugs.
* Install the 2 clips.


Important: The radio must engage audibly.


5. Install the radio.
Connect the 2 wiring harness plugs.
6. Connect the battery.
7. For programming procedures, refer to Control Module References (Programming and Relearning) .