Sunroof / Moonroof Motor: Service and Repair

Power Sunroof Motor Replacement

Removal Procedure

1. Lower the molded headlining. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (with Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair) .




2. Remove the power sunroof motor.

1. Remove the 3 bolts (1).
2. Disconnect the wiring harness plug (2).




Installation Procedure

1. Install the power sunroof motor.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Connect the wiring harness plug.

Tighten the 3 bolts to 7 N.m (62 lb in).

3. Install the molded headlining. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (with Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair) .

Important: Open and close the sliding sunroof fully.


4. For programming procedures, refer to Control Module References (Programming and Relearning) .