Instrument Panel Center Trim Panel Replacement

Instrument Panel Center Trim Panel Replacement

Removal Procedure





1. Remove the radio.

1. Disconnect with the dismantling strap, arrow.
2. Disconnect the wiring harness plug (2).
3. Disconnect the antenna (1).





2. Remove the heating/air conditioning control module.

1. Loosen the 2 top clips (1).
2. Loosen the 2 bottom clips.
3. Release the 2 wiring harness plugs and disconnect (2).





3. Remove the instrument panel (I/P) center trim panel.

1. Remove the 2 bolts (2).
2. Release and disconnect the wiring harness plug (1).
3. Remove the center trim panel.




Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the center trim panel.
Connect and latch the wiring harness plug.

Tighten the 2 bolts to 2.5 N.m (22 lb in).

2. Install the heating/air conditioning control module.

1. Connect and lock the 2 wiring harness plugs.
2. Install the 4 clips.

3. Install the radio.

1. Install the antenna.
2. Connect the wiring harness plug.
3. Slide the radio in until it clicks in.