Part 3 of 4

docid=1827841




50. Connect the engine wiring harness electrical connector to the EVAP canister purge solenoid valve.
51. Connect the engine wiring harness electrical connector to the MAP sensor.




52. Connect the engine wiring harness electrical connector (1) to the throttle actuator.
53. Connect the engine wiring harness electrical connector (2) to the knock sensor.
54. Install the engine wiring harness clip (3) to the intake manifold brace.




55. Connect the engine wiring harness electrical connector (1) to the fuel injector jumper electrical connector.




56. Install the positive battery cable terminal (3) to the generator.
57. Install the generator terminal nut (1).

Tighten the nut to 20 N.m (15 lb ft).

58. Position the positive battery cable terminal boot (4).
59. Connect the engine wiring harness electrical connector (4) to the A/C compressor.




60. Connect the engine wiring harness electrical connector (1) to the generator.




61. Connect the engine wiring harness electrical connector (2) to the knock sensor.
62. Install the engine wiring harness clip (1) to the oil level indicator tube bracket.




63. Connect the engine wiring harness electrical connector (1) to the transmission oil cooler pump.




64. Position the negative/positive battery cable to the engine.
65. Install the negative battery cable ground terminal (5) to the engine lift bracket.
66. Install the negative battery cable ground bolt (6) to the front engine lift bracket.

Tighten the bolt to 25 N.m (18 lb ft).

67. Install NEW tie straps (1) to the engine wiring harness.




68. Connect the engine wiring harness electrical connector (1) to the MAF sensor.
69. Raise the vehicle.




70. Install the engine wiring harness terminal (3) to the starter.
71. Install the engine wiring harness terminal (1) to the starter.
72. Install the engine wiring harness terminal nut (2) to the starter.

Tighten the nut to 3 N.m (27 lb in).

73. Install the engine wiring harness clip (4) to the oil level indicator tube.




74. Install the positive battery cable lead (3) to the starter.
75. Install the positive battery cable lead nut (2) at the starter.

Tighten the nut to 10 N.m (89 lb in).

76. Install the engine wiring harness clip (4) to the oil level indicator tube bracket.




77. Connect the engine wiring harness electrical connector (1) to the brake booster vacuum pump.




78. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
79. Connect the engine wiring harness electrical connector (2) to the oil pressure sensor.
80. Lower the vehicle.




81. Install the heater inlet (1) and outlet (2) hoses to the thermostat housing.
82. Position the heater inlet and outlet hose clamps at the thermostat housing.




83. Position the air bleed hose to the engine.
84. Install the surge tank air bleed hose to the engine.
85. Install the surge tank air bleed hose clip (3) to the surge tank bracket.
86. Position the surge tank air bleed hose clamp (1) at the engine.




87. Install the surge tank clip (1) to the oil level indicator tube bracket.
88. Position the surge tank outlet hose clamp (2) at the surge tank.