Wiring Harness: Service and Repair

Wiring Harness Replacement

Removal Procedure

Tools Required

J 41101 Transaxle Connector Remover

1. Remove the transmission side cover.
2. Remove the control valve body.




3. Push the J 41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs.
4. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
5. Remove the wiring harness (11).

Installation Procedure





Connect the wiring harness assembly to the following components:

* The TFP switch assembly (13)
* The pressure control solenoid (312) (red connector)

Important: The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.

* The 1-2 shift solenoid (305) (white connector)
* The 2-3 shift solenoids (305) (white connectors)
* The TCC solenoid (335)
* Install the control valve body.
* Install the transmission side cover.

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

* Reset the TAP values. Refer to Transmission Adaptive Functions.