Manifold Absolute Pressure Sensor Replacement (SCIP)

Manifold Absolute Pressure Sensor Replacement (SCIP)

Removal Procedure




1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
2. Remove the SCIP sensor (1) from the supercharger.

Important: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.

3. Inspect the seal for damage.

Installation Procedure






Important: Use the new SCIP sensor seal provided with the new SCIP sensor.

Notice: Refer to Fastener Notice.

1. Install the SCIP sensor (1) into the intake manifold.

Tighten the bolt to 10 N.m (89 lb in).

2. Connect the SCIP sensor harness connector.