8. Transaxle Case Disassemble

Transaxle Case Disassemble

Tools Required
^ 87-90-800 Drift, Differential Seal
^ 87-91-311 Bearing Driver Shaft Sleeve
^ 87-92-236 Support





1. Remove the input shaft bearing retainer screws and the retainer.





2. Press out the input shaft bearing race using the 87-90-800. Use the 87-92-236 as a base for the pressing operation.





3. Press out the output shaft bearing race using the 87-91-311.





4. Remove the transaxle vent filter from the case using a punch. Drive the vent from the outside to the inside.