SIR Disabling and Enabling Zone 5

SIR DISABLING AND ENABLING ZONE 5

DISABLING PROCEDURE




1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module fuse center, then remove the fuse center cover.
5. Locate and remove the AIR BAG fuse from the body control module fuse center.

IMPORTANT: With the AIR BAG fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.




6. Remove the passenger/right outer trim cover from the instrument panel (I/P) (3).
7. Remove the connector position assurance (CPA) from the I/P module connector (2).
8. Disconnect the I/P module connector (1) from the vehicle harness connector (2).

ENABLING PROCEDURE
1. Remove the key from the ignition switch.




2. Connect the I/P module connector (1) to the vehicle harness connector (2).
3. Install the CPA to the I/P module connector (2).
4. Install the right outer trim cover to the I/P (3).




5. Install the AIR BAG fuse into the body control module fuse center.
6. Install the body control module fuse center cover.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.