94. Spacer Plate and Gaskets Installation

Spacer Plate and Gaskets Installation
1. Inspect the spacer plate for damage.





2. If damaged, replace the spacer plate (23).





3. Install a new spacer plate to channel plate gasket (24) onto the channel plate.
4. Install the spacer plate (23) on top of the gasket and channel plate.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the spacer plate support (21) and the two bolts (20) onto the spacer plate. Hand start the bolts.
Tighten the bolts to 14 Nm (10.5 ft. lbs.).