Tail Lamp Replacement (Sedan)

TAIL LAMP REPLACEMENT (SEDAN)

REMOVAL PROCEDURE




1. Open the rear compartment.
2. Pull back the side carpet to gain access to the tail lamp.
3. Remove the nuts from the tail lamp.
4. Gently pull the tail lamp housing straight back.
5. Disconnect the electrical connector from the tail lamp.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the tail lamp.
2. Position tail lamp to the quarter panel and push in until fully seated.
3. Install the nuts to the tail lamp.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 3.5 N.m (31 lb in).

4. Reposition the side carpet.
5. Close the rear compartment.