SIR Disabling and Enabling Zone 6 (Coupe)

SIR DISABLING AND ENABLING ZONE 6 (COUPE)

DISABLING PROCEDURE




1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module fuse center, then remove the fuse center cover.
5. Locate and remove the AIR BAG fuse from the body control module fuse center.

IMPORTANT: With the AIR BAG fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.

6. To disable the roof rail module-right, perform steps 7-9. To disable both the roof rail module-right and the seat belt pretensioner-RF, continue to step 7.




7. Remove the garnish molding from the upper lock pillar.
8. Remove the connector position assurance (CPA) from the roof rail module-right connector.
9. Disconnect the roof rail module-right connector from the vehicle harness connector.




10. Lower headliner to access the seat belt pretensioner-RF connector.
11. Remove the CPA from the seat belt pretensioner-RF connector.
12. Disconnect the seat belt pretensioner-RF connector.

ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the roof rail module-right, skip to step 6. To enable both the roof rail module-right and the seat belt pretensioner-RF, continue to step 3.




3. Connect the roof rail module-right connector to the vehicle harness connector.
4. Install the CPA to the roof rail module-right connector.
5. Install the garnish molding to the upper lock pillar.




6. Connect the seat belt pretensioner-RH connector and install the CPA.
7. Install the headliner.




8. Install the AIR BAG fuse into the body control module fuse center.
9. Install the body control module fuse center cover.
10. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
11. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Restraint Systems.