Oil Level Control Valve

OIL LEVEL CONTROL VALVE

REMOVAL

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON THE HOIST. TO HELP AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.

1. Position vehicle on hoist and raise vehicle.





2. Remove transaxle oil pan.
3. Remove oil level control valve. Pull valve straight out. Do not pry on valve.

INSTALLATION

NOTICE: Push straight up on center of valve to prevent damage to case.

1. Install oil level control valve.
2. Install transaxle oil pan.
3. Lower vehicle.
4. Remove A.I.R.





5. Add DEXRON(R) III (P/N 21019223) transaxle fluid (or equivalent).
6. Start engine, warm up transaxle, and check for leaks.
7. Check fluid level.