Right

RIGHT SIDE AXLE SEAL

- TOOLS REQUIRED
- J41102 Axle Seal Installer

REMOVAL
1. Remove stub axle shaft from transaxle.

NOTICE: Be careful not to damage case bore with screwdriver.





2. Use a screwdriver to remove axle seal from case. If necessary, crush seal first in order to loosen seal from case.

INSTALLATION

IMPORTANT: Axle Seal Installer J41102 must be used in order to install seal correctly. The J41102-1 Axle Seal Installing Driver installs axle seal to a given depth.





1. Using J41102-1 Axle Seal Installing Driver, install a new right side axle seal into the transaxle case.

NOTICE: In order to prevent damage to shaft splines during vehicle operation, add grease (P/N 7847638) to splines on stub shaft.





2. Install stub axle shaft and RH axle in transaxle.
3. Check fluid level.
4. Inspect shaft and seal for fluid leaks.