Puller Fan

PULLER FAN

REMOVAL





1. Disconnect negative battery cable.
2. Disconnect positive battery cable.

NOTICE: It is not necessary to disconnect fan control module wiring from module.

3. Remove fan control module by sliding up and off bracket. Lay module and wiring out of the way.
4. Remove battery insulating cover.
5. Remove battery hold down fan control module bracket.

CAUTION: DO NOT TIP BATTERY OVER 45 DEGREE ANGLE OR ACID COULD SPILL.

6. Remove battery.
7. Drain coolant.





8. Remove power steering fluid reservoir to fan shroud bolts and position reservoir rearward in car.





9. Disconnect both cooling fan electrical connectors.
10. Remove electrical connectors from connector retainer by sliding connector as shown.
11. Remove pusher fan electrical harness from fan shroud retainer tabs.





12. Remove upper transaxle cooler line from radiator end tank and unsnap from end tank retainer.
13. Cap or tape off transaxle oil cooler line to prevent oil loss or contamination.





14. Remove upper radiator hose to radiator clamp and remove hose from radiator end tank.





15. Remove fan shroud to radiator bolts and remove.

INSTALLATION

NOTICE: Verify that the pusher fan electrical harness is not between the fan shroud and the radiator.





1. Install fan and shroud assembly onto radiator lower tabs.





2. Install fan shroud to radiator bolts.
Torque:
Fan Shroud-to-Radiator Bolts: 4 Nm (35 inch lbs.)





3. Install upper transaxle oil cooler line into radiator end tank retainer.
4. Remove cap and install upper transaxle oil cooler line to radiator end tank.
Torque: Upper Transaxle Cooler Line-to-Radiator End Tank: 25 Nm (18 ft. lbs.)





5. Route pusher fan electrical harness around outside of radiator end tank to upper fan shroud.
6. Install fan electrical connectors into connector retainers as shown.
7. Connect both fan electrical connectors.
8. Install pusher fan harness under routing tabs on fan shroud.





9. Install upper radiator hose to radiator end tank and position clamp at 12 o'clock position.





10. Install power steering fluid reservoir to fan shroud bolts.
Torque:
Power Steering Fluid Reservoir-to-Fan Shroud Bolts: 5 Nm (44 inch lbs.)





11. Verify battery tray is clean.
12. Install battery.
13. Install battery hold down/fan control module bracket.
Torque:
Battery Hold-Down Bracket: 20 Nm (15 ft. lbs.)

NOTICE: Battery life is reduced if battery insulating cover is not used.

14. Install battery insulating cover.
15. Install fan control module by sliding down onto bracket.
16. Connect positive battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
17. Connect negative battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
18. Fill cooling system.
19. Use fresh water to rinse away any coolant that was spilled during service.