Rear

REMOVAL

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST





1. Raise vehicle on hoist.
2. Remove wheel and tire assemblies.
3. Remove rear stabilizer bar clamp fasteners.
4. Remove stabilizer bar bushings from stabilizer.

INSTALLATION

1. Install stabilizer bar bushings onto stabilizer.
2. Install clamps and tighten.
Torque: 55 Nm (41 ft. lbs.)

NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts to loosen in service.

3. Position wheel onto hub.
4. Install wheel bolts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
Torque: 125 Nm (92 ft. lbs.)
5. Lower vehicle from hoist.