Throttle Body Unit Installation

Throttle Body Connections:

INSTALLATION

1. Inspect manifold opening and remove any loose parts and/or material.
2. Inspect [1][2]intake manifold sealing surface for cleanliness.
3. Remove Loctite(R) gasket sealer from bolt threads. Remove shop towel from throttle body opening and install new flange gasket.
4. Install throttle body assembly. If new throttle body is used, the idle stop screw on the new unit is preset by the manufacturer and should not require adjustment.
5. Apply Loctite(R) 242 Threadlocker (P/N 21485277) or equivalent to the attachment bolt threads. Install throttle body assembly retaining bolts.

Torque to: 31 NM (23 ft. lbs)

6. Install throttle control cable.
7. Connect the vacuum harness.
8. Connect IAC valve and throttle position (TP) sensor electrical connectors. Push in until a click is heard and pull back to confirm positive engagement.
9. Connect negative battery terminal.
10. Install air intake tube and air box cover.
11. Start engine and check for vacuum leaks.