P0141

Diagnostic Chart:

Wiring Diagram:

The heated oxygen sensor (HO2S) is mounted behind the catalytic converter. This sensor is used to determine the oxygen storage capability of the catalytic converter. Oxygen storage capability is used as a measure of converter condition, and its ability to perform its function. Due to the location of the rear HO2S, it requires additional heat to operate properly. This sensor incorporates a heater (12 ohms), which is controlled On or Off by the powertrain control module (PCM). The PCM diagnoses the heater and its related wiring by monitoring electrical current. A DTC P0141 will set if the current range does not fall within the calibrated limits.

DTC PARAMETERS
DTC P0141 will set if the following conditions exist for longer than 50 seconds when catalyst temperature is less than 775°C (1427°F) and:
^ Current feedback is less than 0.5 amps or
^ Current feedback is greater than 2.4 amps.

DIAGNOSTIC AIDS
Normal Scan tool readings in closed loop will show the oxygen sensor voltage varying between 10mV and 999mV