Driver In Differential Clutch, Replacing

Driver in differential clutch, replacing

To remove

1. Remove the Propeller shaft.
2. Remove the driver (A) with a puller.





3. Remove the seal (A) with a screwdriver.





To fit

1. Fit the seal (A) using DT-49065 Fitting drift.





2. Fit the driver (A) using DT-49048 Support.
Tightening torque: 100 ± 5 Nm (73.8 ± 3.7 lbf ft)





3. Check the oil level as specified in Checking/changing fluid in the differential clutch. Check/Change of Oil In the Differential Clutch
4. Fit the Propeller shaft.