Rear Suspension

Rear anti-roll bar bush, 4WD

To remove

1. Raise the car.
2. Mark the position of the bushes.
3. Remove the bush bolts (A) and move aside the anti-roll bar (B).





4. Remove the caps and bushes from the anti-roll bar.

To fit

1. Clean the anti-roll bar and lubricate the inside of the bushes with 91 63 334 Ball bearing grease. Fit the caps and bushes on the anti-roll bar.
2. Apply a thin coat of soapy water on the outside of the bush.

Important
Soap and water solution must not enter between bushing and anti-roll bar!

3. Bend up the anti-roll bar (B) and fit the bush bolts (A).

Tightening torque: 30 Nm (23 lbf ft)





4. Lower the car to the floor.