Procedure CV
Procedure CV1. Remove fuse F5 from the instrument panel electrical centre (IPEC).
2. Fit the fuse.
Note
The pinch protection for door windows has now lost the previously programmed values. Pinch protection will be reprogrammed when the antipinch test is carried out.
3. Carry out the anti-pinch test in Tech2 under the menu, Body - Power Windows - Driver Door/Passenger Door - Miscellaneous - Anti-pinch test Convertible. Use Tech2 version 116.000 or later.
4. If the results of the Tech2 anti-pinch test are positive, no further action is necessary.
5. If the Tech2 anti-pinch test fails, proceed to step 6 and adjust the window(s) specified.
6. Lower the door window fully.
7. Remove the retaining bolt from the inner cover of the door mirror base and prise the cover from the door. Use 82 93 474 Removal tool.
8. Remove the inner cover of the door mirror base by lifting the cover straight up.
9. Driver's side: Unplug the connector from the door mirror switch.
10. Raise the window to its closed position.
11. Undo the four retaining bolts.
12. Undo and remove the adjuster screw.
13. Adjust the door mirror base by holding it so that it is in line with the door window.
14. Adjust the door mirror base so that the door window is angled inward slightly more than the door mirror base. The seal should have a gentle S-shape where it meets the glass.
Note
With the door closed, press the top edge of the glass outward, causing the door mirror base and the glass to form a straight line. This can be checked by pressing the top edge of the glass outward when the door is open.
15. Tighten the four bolts.
16. Insert the adjuster screw and tighten loosely so that it does not rattle.
17. Check that the door mirror and door window align with the A-pillar seal.
18. Check that the door windows and rear side windows operate smoothly by first raising the door windows and then the side windows. Lower all of the windows. Then raise the side windows followed by the door windows.
19. Remove fuse F5 in the instrument panel electrical centre (IPEC).
20. Fit the fuse.
Note
The pinch protection for door windows has now lost the previously programmed values. Pinch protection will be reprogrammed when the antipinch test is carried out.
21. Check using Tech2 that the pinch protection works by carrying out the anti-pinch test in Tech2 under the menu, Body - Power Windows - Driver Door/Passenger Door - Miscellaneous - Anti-pinch test Convertible.
22. Driver's side: Plug in the connector for the door mirror switch.
23. Fit the inner cover of the door mirror base by pressing it into place.
24. Fit the retaining bolt.