Front Suspension

Hub nut 230 Nm (170 ft. lbs.)


Clean the contact surfaces and fit the brake shield and the hub with three bolts.
Make sure that the cable to the wheel sensor fits into position upwards/forwards.
Tightening torque 90 Nm +45° (66 ft. lbs. +45°)

Insert the drive shaft into the hub.
Fit the hub nut and pull the shaft to the correct position with the nut.
Remove the wedge and fit the suspension arm to the steering swivel member.
Tightening torque 50 Nm (37 ft. lbs.)