Joint Pipe

Joint Pipe

Removal
1. Disconnect the ground cable from battery.





2. Disconnect the exhaust temperature sensor connector.





3. Remove the front oxygen (A/F) sensor.
4. Remove the under cover.
5. Remove the lower exhaust manifold cover (RH).





6. Remove the nuts which hold the front exhaust manifold to joint pipe.





7. Remove the center exhaust pipe.
8. Remove the turbocharger.
9. Take off the joint pipe in the upward direction.

Installation
1. Install in the reverse order of removal.
^ Tightening torque:
^ T6: 35 Nm (3.6 kgf-m, 26.0 ft. lbs.)