> on the Vehicle Diagnostic Interface, select the {2. Each System Check}->{Keyless unit mode}->{1. Keyless ID registration}.

Input the 8-digit ID number from the left attached to the plastic bag of transmitter or circuit board inside transmitter.

NOTE: Press the [▴] key on the Vehicle Diagnostic Interface to increase the number, and the [▾] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.

The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.

Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3) and try again.

<> will be displayed and registration started.
<> will be shown when the process is done.

To end, select the <>, and press the [NO] key to return to {1. Keyless ID registration}. If there are additional transmitters to be registered, select the <>, and press the [YES] key to return to the step 3).

NOTE:
- If the registration fails, <> will be shown. Press the [YES] key to return to the {1. Keyless ID registration} and retry from the step 2).
- <> is shown on the Vehicle Diagnostic Interface when four transmitters have been registered. Press the [NO] key to return to {1. Keyless ID registration}.