Seal Ring - Selector Rod, Removed Gearbox

Seal Ring - Selector Rod, Removed Gearbox
To remove





1. Pry out the seal using a narrow screwdriver.

Important; Do not damage the sealing surface on the selector rod.

To fit
1. Clean the selector rod and check that it has no burrs.





2. Wind a layer of thin, smooth plastic tape around the hole in the selector rod.
3. Remove the tape and tap in the seal using 87 90 685 Fitting tool, sealing ring selector shaft and..87 91 709 Clamp. Tap only until the seal is level with the clutch housing.