Bushes For Selector Shafts, Gearcase

Bushes For Selector Shafts, Gearcase
To remove

Important: Bushes should be tapped out before the gearcase is washed as the detergent can destroy the surface of the bushes.





1. Carefully use 87 91 238 Drift, bush selector rod to tap out the three bushes in the gearcase and the bush for the selector shaft in the clutch housing.

To fit

Important: The reverse selector shaft has no bush in the gearcase.





1. Tap the bushes in carefully using 87 91 238 Drift, bush selector rod.