Campaign - R/H Headlamp Cover Replacement
MODIFICATION INSTRUCTIONBulletin Nbr: 351-2326
Date: December 2001
Market: US, CA, JP
Replacing right-hand headlamp cover
Customer Satisfaction Campaign 154 08
Cars in stock must be rectified before delivery.
A personal communication must be sent to the owners of cars already delivered requesting them to get in touch with the nearest Saab garage as soon as possible to have the fault rectified.
Cars affected
Saab 9-5 M02 with petrol engine and within VIN interval 23000132 - 23015458.
Certain cars after VIN 23015235 may already have a cover with the new design.
Background
The right-hand headlamp cover, used when replacing bulbs1 can chafe the wiring harness of the mass air flow sensor. The old cover is replaced with a new one in a new design.
Parts required
54 02 383 Headlamp cover
Procedure
Check box C3 of the modification identity plate before proceeding. Continue as follows if the box has not been marked.
1. Turn the ignition key to the LOCK position.
2. Remove the cover from the rear of the right-hand headlamp and discard it.
3. Fit the new cover.
Marking the modification identity plate.
On completion of the necessary measures, box C3 on the modification identity plate must be marked. If the work was carried out by the importer, mark the box with a "7". If done by a dealer, mark it with an "8".
Time/Warranty information
See separate information.