Belt Pulley on Power Steering Pump

Belt Pulley On Power Steering Pump, V6-Engine
To remove
1. Remove the mass air flow sensor with hose.





2. Detach the power steering servo hose from the holder.
3. Undo the belt pulley bolts slightly.





4. Take the strain off the multigroove V-belt and lift it off the servo pump pulley.
5. Remove the belt pulley.

To fit
1. Fit the belt pulley.
Tightening torque 20 Nm (15 ft. lbs.) + (30°).
2. Take the strain off the belt tensioner and fit the belt. Ensure the belt is fitted correctly on all the belt pulleys.





3. Fit the power steering servo hose to the engine mounting bracket
4. Fit the mass air flow sensor with hose and plug it in.