Support - Half Shaft/Short Shaft: Service and Repair

To Remove
1. Place the intermediate shaft in a vice.





2. Remove the small circlip.
3. Press the shaft out of the bearing with puller 87 91 28 and support 87 92 210





4. Remove the large circlip.
5. Press out the bearing with sleeve 87 91 311 and tool 87 92 23 as support.

To Fit





1. Press in the new bearing using tool 87 90 461 and tool 87 91 31 F+] as support.
2. Fit the large circlip.





3. Press on the intermediate shaft with sleeve 87 90 487
4. Fit the small circlip.