Front Left

To remove
1. Unplug the connector.
2. Raise the car and remove the wheel.
3. Clean the area round the wheel sensor using a soft wire brush.





4. Undo the wheel sensor retaining bolt and remove the wheel sensor.
5. Remove the grommet and withdraw the lead.
6. Detach the lead from the clips and lift out the sensor.

To fit





1. Fit the wheel sensor in its holder and tighten the retaining bolt.
2. Insert the lead.
3. Push the lead into the clips and fit the grommet.
4. Fit the wheel and lower the car.





5. Plug in the connector.
6. Tighten the wheel bolts. The wheel should be off the ground when the bolts are tightened.
Tightening torque: 110 Nm (81 ft. lbs.)