Clutch Housing

Bearing Race For Input Shaft
To Remove





1. Press out the bearing race with Sleeve 87 91 20, using Tool 87 92 236 as support.

To Fit





1. Seat the bearing race using a plastic hammer.
2. Press on the bearing until it stops with Drift 83 90 312 Sleeve 83 90 114 and Sleeve 87 91 31 114 must be used.

Bearing Bushing For Selector Rod
To Remove
The seal ring must have been removed first.





1. Drive out the bearing bushing with Drift 87 91 220

To Fit





1. New bearing bushing is fitted with Drift 87 91 220

Differential Bearing Race In Clutch Housing
To Remove





1. Carefully tap out the bearing race with a hammer and a drift (destructive removal)

IMPORTANT: Tap the same amount on both sides!

To Fit





1. Fit (press) in the new bearing race until it stops with Drift 83 90 12 and Sleeve 87 91 204.
2. Fit a new seal with Drift 87 92 657.