Checking the Control Module Temp Sensor Input, Jumpered

Checking The Control Module's Temperature Sensor Input, Jumpered Connector





- Connect a jumper lead between pin 9 of the female connector and pin 10 of connector H10-5.

Reading: Actual Left Mixed Air Temperature





The reading should be: 0 V

Checking the wiring harness.
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Rectifying the Lead - I

YES - Changing Components