Engine Mounting Rear

To remove





1. Drape protective covers over the wings, remove the covers over the battery and intake manifold.
2. Disconnect the negative battery cable.
3. (man) Remove the stay for the gear-changing linkage from the rear engine mounting bracket.
4. Remove the upper engine mounting retaining nut and the bolts securing it to the subframe.





5. Fit Lifting beam 83 94 850.
6. Raise the car.





7. Remove the engine mounting's upper bracket.
8. Remove the engine mounting with lower bracket.
9. Remove the engine mounting from the lower bracket.

To fit





1. Secure the engine mounting on its lower bracket and fit the wire in place.
2. Position the engine mounting and fit the retaining bolts but do not tighten them.
3. Fit the upper bracket.
Tightening torque: 50 Nm (36 ft. lbs.).
4. Lower the car to the floor.
5. Check the position of the engine mounting and its wire.
6. Remove the lifting beam.





7. Tighten the engine mounting's retaining bolts, using a torque wrench.
Tightening torque: 50 Nm (36 ft. lbs.).
8. Fit the engine mounting's upper retaining nut.
Tightening torque 25 Nm (10 ft. lbs.).
9. Reconnect the negative battery cable and the covers. Set the correct time on the clock. Calibrate the ACC.