Bus and Diagnostics Communication

No Bus data From TRIONIC.









Fault symptoms
No bus communication with Trionic

Condition
The following conditions are applicable:

TCM:
- The automatic transmission's input shaft speed exceeded 200 rpm once during the present drive cycle
- No communication for 4 seconds.

Diagnostic help
Some of the following symptoms can perhaps be observed:
- Diagnostic trouble codes P1923, P1908, P1901 or P1902 in Trionic (if the Trionic can be contacted)
- Additional diagnostic trouble code in the TCM (P1902).
- Misfiring.
- Engine fails to start.
- Automatic transmission in Limp-Home mode (CHECK ENGINE lamp on)

Checking the wiring harness
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short-circuits in the leads.

Observe the multimeter, test lamp or diagnostic tool during the test.