Checking Speed Data From the ABS

Checking Speed Data From The ABS





Unplug the connector:
- H43-1
- Extract pin 16 from the male half of the connector





- Plug in the connector.









- Connect a test lamp to B+ and pin 16 (male).





- Raise the rear end of the car.





- Turn the Ignition switch to the ON position.





- Rotate the LH rear wheel.





- The test lamp should flash.

Is the function correct?

NO - Continue with Checking Speed Data from the ABS.

YES - Check, Speed Signal





Check the lead and repair or replace it as necessary.

After performing this procedure Final Check