Support - Half Shaft/Short Shaft: Service and Repair

To Remove





1. Place the intermediate shaft in a vice.
2. Remove the small circlip.
3. Press the shaft out of the bearing with puller 87 91 281 and support 87 92 210.





4. Remove the large circlip.
5. Press out the bearing with sleeve 87 91 204 and tool 87 92 236 as support.

To Fit





1. Press in the new bearing using tool 87 90 461 and tool 87 91 311 as a holder.
2. Fit the large circlip.
3. Press on the intermediate shaft with sleeve 87 90 487





4. Fit the small circlip.