Front Suspension

Anti-roll bar
To remove





1. Raise the car and remove the rear wheels.
2. Remove the anti-roll bar retaining nuts and bolts.
3. Remove the anti-roll bar.

To fit





1. If necessary, grease the anti-roll bar bushes with Molycote 33 (the bushes on new anti-roll bars are greased), position the antiroll bar and fit all bolts and nuts.
2. Tighten the nuts and bolts.
Tightening torque 50 Nm (40 ft. lbs.)
Refit the wheels.
Tightening torque 120 Nm (90 ft. lbs.)
4. Lower the car to the floor.