With Scan Tool

1. Checking The Fault Symptoms

Is the SPORT mode in TCM functioning correctly?

NO
Go to step 10

YES
Go to step 2

2. Checking Control Module Input





Unplug the connector
Main instrument unit 20-pin connector (540)

Go to step 3

3. Checking Control Module Input

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

Connect test lamp 86 11 857 to B+ and pin 19 of the female connector.

Go to step 4

4. Checking Control Module Input





Turn the ignition switch to the ON position.





Contact TCM.
Activate, SPORT Lamp (ON)





The test lamp should light.

Checking the wiring harness
Jiggle the leads and in-line connectors at several places and indifferent directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO
Go to step 5

YES
Go to step 6

5. Rectifying The Lead





Rectify the lead between the pin 19 on the MIU 20 pin connector and pin 24 on TCM.

When repair is complete
Go to step 7

6. Changing Components





Check and replace faulty bulb.

When repair is complete
Go to step 7

7. Final Check





Clear diagnostic trouble codes





Carry out a functionality test.

Is the function correct?

NO
Go to step 9

YES
Go to step 8

8. Final Check

Diagnosis is complete
The steps taken to rectify the fault were correct.

9. Internal Control Module Fault

Diagnostic procedure for this symptom is complete
Refer to Transmission Control Systems, Testing and Inspection, Procedures for Before Changing A Control Module.