Microphone

To remove:





1 Remove the sunvisors. (Note: be sure to replace the anti-rattle tape during re-assembly.)





2 Remove the upper A-pillar trim, and the upper windshield trim. Disconnect the lamp and unclip the microphone.





3 Disconnect the electrical connector for the microphone.

To fit:





1 Connect the electrical connector.

2 Bend the microphone clip in half (using pliers or your hands to increase tension).





3 Tape the microphone to the A-pillar and add anti-rattle tape to the connector.





4 Clip the microphone to the upper trim panel, reconnect the lamp and snap the trim panel back in place.

5 Refit the remaining components in reverse order of removal.





Wiring Diagram








Connector Housing Configuration:
VIU/VCU Connectors C1 and C2





Connector Housing Configuration:
VCU Connector C14





Connector Housing Configuration:
3-Button Connector C18