Checking the Filament Monitor, RH Main Beam

Checking the Filament Monitor, RH Main Beam







- Remove component: Filament monitor for front lamps






















- Connect a Jumper lead between pins 4 and 6 of the relay holder.
- The lamp should come on

Checking the wiring harness.
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Rectifying the Lead - II

YES - Changing Components - I