Ignition System: Service and Repair

To remove







1. Unplug the 10-pin ignition discharge module connector.
2. Remove the 4 screws.
3. Lift up the module.

To fit







1. Apply Krytox (part no.30 19 312) to the rubber seals and fit the ignition discharge module.
2. Fit the 4 screws.
Tightening torque 11 Nm (81 lbf ft)
3. Spray the 10-pin ignition discharge module connector with Kontakt 61 (part no.30 04 520). Plug in the connector.